Agilent Technologies ESA-E Series Programmer's Manual page 309

Language Reference
SYSTem Subsyste m
Power On Time
SYSTem:PON :TIME ?
Returns the number of milliseconds that have elapsed since the
analyzer was last turned on .
Front Panel
Access : none
Power On Type
:SYSTem:PON:TYPE PRESetILAS T
SYSTem :PON:TYPE ?
Sets the defined instrument conditions after a power-on or Preset .
PRESet - The instrument settings at power-on will be either the factor y
preset or user preset, as set by : SYSTem : PRESet :TYPE FACTory USER .
LAST - The instrument settings at power-on will be the settings at th e
time of power down .
Factory Prese t
and *RST: The factory default is Preset . This parameter is
persistent, which means that it retains the settin g
previously selected, even through a power cycle .
Front Panel
Access :
System, Power On/Preset, Power On Last Prese t
Enable IF/Video/Sweep Output Ports
SYSTem :PORTs :IFVSweep :ENABle OFFIONIO1 1
SYSTem :PORTs :IFVSweep :ENABle ?
This command enables or disables the IF, video, and sweep output ports
for Agilent ESA analyzers having options A4J (IF, Sweep, and Vide o
Ports) and AYX (Fast Time Domain Sweeps) . This command is only
available on analyzers with firmware revision A .04.00 and later.
NOTE This command is only available with firmware revision A .04.00 or later.
Factory Prese t
and *RST: O n
Example : : SYST :PORT : IFVS : ENAB ON
Range : On/Of f
Remarks: Disable the output ports for faster measurement times .
Chapter 5
5-149