Agilent Technologies ESA-E Series Programmer's Manual page 277

Language Reference
[:SENSe] :SWEep Subsectio n
[:SENSe]:SWEep Subsection
Sweep Points
[ :SENSe] :SWEep :POINts <number of points >
[ :SENSe] :SWEep :POINts ?
This command sets the number of sweep points .
Factory Preset
and *RST:
Example :
Range :
firmware revision A .05 .00 and later)
Remarks : This command is only available on analyzers with
firmware revision A .04 .00 and later. The number of
sweep points can be set only with Agilent ESA models
E4401B, E4402B, E4404B, E4405B, and E4407B .
Sweep points for ESA Models E4403B, E4408B, an d
E4411B are fixed at 401 points . The number of sweep
points
~tG 111 « .ay , l_ U_G queried
WI
with
111111W W
,
Ull
..11
analyzers wit1 . .
fi_-., .__
are
revision A.04 .00 and later.
Whenever the number of sweep points change, the
following functions are affected:
• All trace data is erase d
• Any traces in view mode will go to blank mode
• Sweep time is re-calculate d
• Any limit lines that are on will be turned of f
Sweep, Points
Query Number of Segments
[ :SENSe] :SWEep :SEGMent :COUNt ?
Returns the number of segments that have been defined .
401
:SWE :POIN 40 1
101 to 8192, (2 to 8192 in zero span for analyzers wit h
Front Panel
Access :
Chapter 5 5-117