Language Reference
[:SENSe] :CORRection Subsectio n
Front Panel
Access :
AMPLITUDE/Y Scale, Corrections, Modify
AMPIITUDE/Y Scale, Corrections, Modify, Select, Antenna
AMPLITUDE/Y Scale, Corrections, Modify, Select, Cabl e
AMPLITUDE/Y Scale, Corrections, Modify, Select, Othe r
AMPLITUDE/Y Scale, Corrections, Modify, Select, Use r
AMPLITUDE/Y Scale, Corrections, Modify, Edit, Poin t
AMPLITUDE/Y Scale, Corrections, Modify, Edit, Frequenc y
AMPLITUDE/Y Scale, Corrections, Modify, Edit, Amplitud e
AMPLITUDE/Y Scale, Corrections, Modify, Edit, Delete Point
Merge Additional Values into the Existing Amplitud e
Correction Data
[ :SENSe] :CORRection :CSET[1]I21314 :DATA :MERGe
<freq>,<rel ampl>{,<freq>,<rel ampl> }
Adds the points with the specified values to the current amplitude
correction data, allowing you to merge correction data . If too much dat a
is merged, as many points as possible are merged into the existing dat a
and then an error is reported .
• <freq> is the frequency (in Hz) where the correction should b e
applied; no unit is allowed in this paramete r
• <rel_ampl> is the amount of relative amplitude correction (in dB )
needed; no unit is allowed in this paramete r
Remarks:
CSET number equivalents to front panel acces s
definitions are as follows :
CSET1 is Antenn a
CSET2 is Cabl e
CSET3 is Othe r
CSET4 is Use r
Delete Amplitude Correction
[ :SEMI] :CORRection :CSET[1]~2~3~4 :DELete
Deletes the specified correction set . If the set was On, it is turned Off.
Front Panel
Access :
AMPLITUDE/Y Scale, Corrections, Modify, Delet e
5-92
Chapter 5