Agilent Technologies ESA-E Series Programmer's Manual page 172

Language Reference
CALibration Subsystem
Turns the automatic alignment on and off . This is run continuously, at
the end of each sweep.
Factory Preset
and *RST: On at power-u p
Front Panel
Access :
System, Alignments, Auto Align, Al l
System, Alignments, Auto Align, All but R F
System, Alignments, Auto Align, Of f
Return to the Default Alignment Dat a
:CALibration :DATA :DEFault
Initializes the alignment data to the factory defaults .
Front Panel
Access :
System, Alignments, Load Defaults
Align FM Demodulation
CALibration:Fl4Demo d
CALibration: FMD od?
Performs an alignment of the FM Demodulation board if Option BA A
(FM Demodulation) is installed . The query form of this comman d
performs the alignment and returns zero if the alignment is successful .
NOTE Both this command and front panel access are available only whe n
Option BAA (FM Demodulation) is installed.
Front Panel
Access :
System, Alignments, Align Now, FM Demod
Query the Internal or External Frequency Referenc e
:CALibration :FREQuency :REFerence ?
This is a query only.
Front Panel
Access :
non e
Coarse Adjust the Frequency Reference
:CALibration :FREQuency :REFerence :COARse <setting>
CALibration :FREQuency :REFerence :COARse ?
5-12 Chapter 5