Agilent Technologies ESA-E Series Programmer's Manual page 305

Language Reference
SYSTem Subsystem
This command is available only on analyzers having Option 1AX . Only
one Option 1AX can be installed in an instrument .
Factory Prese t
(no *RST) : The factory default is 9600 . This parameter is
persistent, which means that it retains the settin g
previously selected, even through a power cycle .
Range : Supported baud rates ar e
110 300 600 1200 2400 4800 9600 19200 38400
I
57600 11520 0
Front Panel
Access:
System, Remote Port
Serial Port Receive Pace Setup
:SYSTem : COHMunicate :SERial[1]I213I415I617I8[ :RECeive] :PACE
RONINONE
:SYSTem :CCl4Municate :SERial[1]I 2131415161718[ :RECeive] :PACE
Set the receive pace to on or none for an instrument, with the RS-23 2
interface installed . This command is available only on analyzers havin g
Option 1AX. Only one Option 1AX can be installed in an instrument .
Factory Prese t
(no *RST) : The factory default is none . This parameter is
persistent, which means that it retains the settin g
previously selected, even through a power cycle .
Front Panel
Access:
non e
Serial Port Transmit Pace Setup
:
SYSTem:COMunicate : SERial [1 ] 12131415161718 : TRANsmit : PACE
RONINONE
:SYSTem:CCNMunicate :SERial[1]12131415161718 :TRANsmit :PACE ?
Set the transmit pace to on or none for an instrument, with the RS-23 2
interface installed. This command is available only on analyzers havin g
Option 1AX. Only one Option 1AX can be installed in an instrument.
Factory Prese t
(no *RST) : The factory default is none. This parameter is
persistent, which means that it retains the settin g
previously selected, even through a power cycle .
Front Panel
Access :
non e
Chapter 5 5-145