Agilent Technologies ESA-E Series Programmer's Manual page 173

Language Reference
CALibration Subsyste m
Allows coarse adjustment of the internal 10 MHz reference oscillato r
timebase of the analyzer.
NOTE
:CALibration :ALL is required after COARse is set.
Range : Integer, 0 to 25 5
Front Panel
Access :
System, Alignments, Time Base, Coarse
Fine Adjust the Frequency Referenc e
:CALibration :FREQuency :REFerence :FINE <setting>
CALibration :FREQuency :REFerence :FINE ?
Allows fine adjustment of the analyzer internal 10 MHz referenc e
oscillator timebase .
NOTE :CALibration :ALL is required after FINE is set.
Range : Integer, 0 to 25 5
Front Panel
Access :
System, Alignments, Time Base, Fine
Select the Frequency Correction s
:CALibration :FREQuency[ :STATe] OFFIONI01 1
CALibration :FREQuency[ :STATe] ?
Turns on or off the frequency corrections .
Factory Prese t
and *RST: On
Front Panel
Access:
System, Alignments, Freq Correct On Of f
Align the RF Circuitry
CALibration :RF
CALibration :RF?
Performs an alignment of the RF assembly.
Chapter 5 5-13