Radware Alteon Application Manual page 92

Alteon Application Switch Operating System Application Guide
Port Trunking
>> # /cfg/l2/trunk 1
>> Trunk group 1# add 2
>> Trunk group 1# add 12
>> Trunk group 1# add 15
>> Trunk group 1# ena
3. Apply and verify the configuration.
>> Trunk group 1# apply
>> Trunk group 1# cur
4. Examine the resulting information. If any settings are incorrect, make appropriate changes.
5. Save your new configuration changes.
>> Trunk group 1# save
6. Repeat the process on Alteon 2.
>> # /cfg/l2/trunk 3
>> Trunk group 3# add 6
>> Trunk group 3# add 11
>> Trunk group 3# add 16
>> Trunk group 3# ena
>> Trunk group 3# apply
>> Trunk group 3# cur
>> Trunk group 3# save
Trunk group 1 (on Alteon 1) is now connected to trunk group 3 (on Alteon 2).
7. Examine the trunking information on each Alteon.
>> /info/l2/trunk
Information about each port in each configured trunk group is displayed. Make sure that trunk
groups consist of the expected ports and that each port is in the expected state.
Notes
• Any physical port can belong to only one trunk group.
• Up to eight ports can belong to the same trunk group.
• Best performance is achieved when all ports in any given trunk group are configured for the
same speed.
• Trunking from non-Alteon devices must comply with Cisco EtherChannel technology.
92
(Select trunk group 1)
(Add port 2 to trunk group 1)
(Add port 12 to trunk group 1)
(Add port 15 to trunk group 1)
(Enable trunk group 1)
(Make your changes active)
(View current trunking configuration)
(Select trunk group 3)
(Add port 6 to trunk group 3)
(Add port 11 to trunk group 3)
(Add port 16 to trunk group 3)
(Enable trunk group 3)
(Make your changes active)
(View current trunking configuration)
(Save for restore after reboot)
Document ID: RDWR-ALOS-V2900_AG1302