Radware Alteon Application Manual page 719

>> Real server group 1# /cfg/slb/virt 1
>> Virtual server 1# dname gslb.example.com
>> Virtual server 1# service 80/hname www
To define other services (such as FTP), make additional hostname entries.
6. Apply and verify the configuration.
>> Global SLB# apply
>> Global SLB# cur
7. Examine the resulting information. If any settings are incorrect, make and apply any appropriate
changes, and then check again.
>> Global SLB# /cfg/slb/cur
8. Save your new configuration changes.
>> Layer 4# save
To configure the basics at the Denver Site
Following the same procedure described for San Jose (see
Site, page 714), configure the Denver site as follows:
1. Optionally, on the Denver Alteon, configure management access and the management gateway
address.
>> # /cfg/sys/mmgmt/addr 49.133.88.31
>> Management Port# mask 255.255.255.0
>> Management Port# gw 49.133.88.1
>> Management Port# ena
2. If you are using the BBI for managing the San Jose Alteon, change its service port.
By default, GSLB listens on service port 80 for HTTP redirection. By default, the BBI also uses
port 80. Both services cannot use the same port. If the BBI is enabled, configure it to use a
different port.
Note: Use the
/cfg/sys/access/http
For example, enter the following command to change the BBI port to 8080:
>> # /cfg/sys/wport 8080
3. Configure a VLAN for the Internet traffic.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Select Virtual Server 1)
(Define domain name)
(Define HTTP hostname)
To configure the basics at the San Jose
(Management port IP address)
(Management. port mask)
(Management. port gateway address)
(Enable the management port)
command to enable BBI.
Global Server Load Balancing
719