Radware Alteon Application Manual page 305

Configuring WAP SLB using RADIUS Snooping
This procedure references
To configure WAP SLB using RADIUS snooping
1. Before you start configuring WAP load balancing:
— Enable Layer 3 server load balancing.
>> # /cfg/slb/virt <number> /layr3 ena
— Enable UDP under the WAP services (ports 9200 to 9203) menu.
>> # /cfg/slb/virt <number> /service <name|number> /protocol udp
— Configure for RADIUS services 1812, 1813, and 1645.
>> # /cfg/slb/virt <number> /service <name|number> /protocol udp
Note: The RADIUS service number specified on Alteon must match the service specified on the
server.
2. Configure Alteon for basic SLB.
>> # /cfg/slb/on
3. Configure IP addresses for the RADIUS/WAP gateways.
>> # /cfg/slb/real 1/rip 1.1.1.100
>> Real server 1# ena
>> # /cfg/slb/real 2/rip 2.2.2.100
>> Real server 2# ena
>> # /cfg/slb/real 3/rip 3.3.3.100
>> Real server 3# ena
4. Create a group to load balance the WAP gateways.
>> # /cfg/slb/group 100
>>Real Server Group 100# add 1
>>Real Server Group 100# add 2
>>Real Server Group 100# add 3
5. Enable the external notification from WAP gateway to add and delete session requests if you are
using static session via TPCP.
>> # cfg/slb/adv/tpcp ena
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
Figure 46 - Load Balancing WAP Gateways, page
Load Balancing Special Services
301.
(Define address for WAP Gateway1)
(Enable Real Server 1)
(Define address for WAP Gateway 2)
(Enable Real Server 2)
(Define address for WAP Gateway 3)
(Enable Real Server 3)
(Define a group)
(Add Real Server 1)
(Add Real Server 2)
(Add Real Server 3)
305