Radware Alteon Application Manual page 697

2. Define and enable VLAN 2 for ports 25 and 26.
>> # /cfg/l2/vlan 2/ena/def 25 26
3. Turn off the Spanning Tree Protocol (STP).
>> # /cfg/l2/stg #/off
4. Define the clean-side IP interfaces. Create one clean-side IP interface on a different subnet for
each VPN device being load balanced.
>> # /cfg/l3/if 1/ena/mask 255.255.255.0/addr 30.0.0.11
>> # /cfg/l3/if 2/ena/mask 255.255.255.0/addr 20.0.0.20/vl 2
>> # /cfg/l3/if 3/ena/mask 255.255.255.255/addr 20.0.0.21/vl 2
5. Configure routes for each of the IP interfaces you configured in
gateways. One static route is required for each VPN device being load balanced.
>> #/cfg/l3/route>> # add 10.0.0.10 255.255.255.255 20.0.0.101 2
>> # add 10.0.0.11 255.255.255.255 20.0.0.102 3
>> # add 10.0.0.20 255.255.255.255 20.0.0.101 2
>> # add 10.0.0.21 255.255.255.255 20.0.0.102 3
6. Configure Virtual Router Redundancy Protocol (VRRP) for Virtual Routers 1 and 2.
>> # /cfg/l3/vrrp/on
>> Virtual Router Redundancy Protocol# vr
>> VRRP Virtual Router 1# ena
>> VRRP Virtual Router 1# vrid
>> VRRP Virtual Router 1# if
>> VRRP Virtual Router 1# addr 30.0.0.50
>> VRRP Virtual Router 1# share dis
>> VRRP Virtual Router 1 # track/vrs ena
>> VRRP Virtual Router 1 Priority Tracking# /cfg/l3/vrrp/vr 2
>> VRRP Virtual Router 2# ena
>> VRRP Virtual Router 2 # vrid 2
>> VRRP Virtual Router 2 # if 2
>> VRRP Virtual Router 2 # addr 20.0.0.1
>> VRRP Virtual Router 2 # share dis
>> VRRP Virtual Router 2 # track/ports ena
7. Enable SLB.
VRRP Virtual Router 2 Priority Tracking# /cfg/slb on
8. Configure real servers for health checking VPN devices.
>> Layer 4# /cfg/slb/real 1/ena/rip 10.0.010
>> Real server 1# /cfg/slb/real 2/ena/rip 10.0.0.11
>> Real server 2# /cfg/slb/real 3/ena/rip 10.0.0.20
>> Real server 3# /cfg/slb/real 4/ena/rip 10.0.0.21
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
Virtual Private Network Load Balancing
step 4, using the VPN devices as
697