Radware Alteon Application Manual page 211

8. Configure real servers and a real server group.
>> Main# /cfg/slb/real 1
>> Real Server 1# ena
>> Real Server 1# rip 30.1.1.13
>> Main# /cfg/slb/real 2
>> Real Server 2# ena
>> Real Server 2# rip 30.1.1.14
>> Main# /cfg/slb/real 3
>> Real Server 3# ena
>> Real Server 3# rip 30.1.1.15
>> Main# /cfg/slb/group 1
>> Real Server Group 1# ena
>> Real Server Group 1# health http
>> Real Server Group 1# add 1
>> Real Server Group 1# add 2
>> Real Server Group 1# add 3
9. Configure client and server processing on the client and server ports.
>> Main# /cfg/slb/port 1
>> SLB Port 1# client ena
>> Main# /cfg/slb/port 13
>> SLB Port 13# server ena
>> Main# /cfg/slb/port 14
>> SLB Port 14# server ena
>> Main# /cfg/slb/port 15
>> SLB Port 15# server ena
10. Configure a PIP and enable it on the client port.
The PIP address is used to converge the IPv4 and IPv6 traffic. Optionally, the PIP address can be
assigned to a VLAN instead of the port. To enable it on the VLAN, use the command
/cfg/slb/pip/type vlan
>> Main# /cfg/slb/pip/type port
>> Proxy IP Address# add 70.1.1.1 1
>> Main# /cfg/slb/port 1
>> SLB Port 1# proxy ena
11. Apply and save the configuration.
>> Management Port# apply
>> Management Port# save
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
, instead of
/cfg/slb/pip/type port
Server Load Balancing
.
211