Radware Alteon Application Manual page 727

2. On the Tokyo Alteon, assign each remote distributed service to a local virtual server.
In this step, the local site, Tokyo, is configured to recognize the services offered at the remote
San Jose and Denver sites. As before, configure one real server entry on the Tokyo Alteon for
each virtual server located at each remote site.
The new real server entry is configured with the IP address of the remote virtual server, rather
than the usual IP address of a local physical server. Do not confuse this value with the IP
interface address on the remote Alteon.
>> # /cfg/slb/real 1
>> Real server 1# ena
>> Real server 1# name San_Jose
>> Real server 1# rip 200.200.200.100
>> Real server 1# adv/remote enable
>> # /cfg/slb/real 2
>> Real server 2# ena
>> Real server 2# name Denver
>> Real server 2# rip 74.14.70.200
>> Real server 2# adv/remote enable
Note: You should note where each configured value originates, or this step can result in
improper configuration.
3. Define a network that will match and accept all incoming traffic for the other sites.
>> # /cfg/gslb/net 1
>> Network 1# ena
>> Network 1# sip 0.0.0.0
>> Network 1# mask 0.0.0.0
>> Network 1# addreal 1
>> Network 1# addreal 2
4. Define a new rule that will make the new network active.
>> # /cfg/slb/gslb/rule 1/ena
>> Rule 1# dname gslb.example.com
>> Rule 1# metric 1/gmetric network
>> Rule 1# metric 1/addnet 1
5. Apply and verify the configuration.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Create an entry for San Jose)
(Enable the real server entry)
(Set a name for the real server
entry)
(Set remote VIP address of San
Jose)
(Define the real server as remote)
(Create an entry for Denver)
(Enable the real server entry)
(Set a name for the real server
entry)
(Set remote VIP address for Denver)
(Define the real server as remote)
(Create an entry for the new
network)
(Enable the new network)
(Define a source IP address match)
(Define a network mask match)
(Add the San Jose site to the
network)
(Add the Denver site to the network)
(Enable the new rule)
(Define a domain name)
(Define the metric this rule will use)
(Add network to the rule metric)
Global Server Load Balancing
727