Radware Alteon Application Manual page 161

>> IP Interface 2 # /cfg/l3/ospf/on
8. Define the backbone.
>> Open Shortest Path First # aindex 0
>> OSPF Area (index) 0 # areaid 0.0.0.0
>> OSPF Area (index) 0 # type transit
>> OSPF Area (index) 0 # enable
9. Define the stub area.
>> OSPF Area (index) 0 # /cfg/l3/ospf/aindex 1
>> OSPF Area (index) 1 # areaid 0.0.0.1
>> OSPF Area (index) 1 # type stub
>> OSPF Area (index) 1 # enable
10. Attach the network interface to the backbone.
>> OSPF Area (index) 1 # /cfg/l3/ospf/if 1
>> OSPF Interface 1 # aindex 0
>> OSPF Interface 1 # enable
11. Attach the network interface to the stub area.
>> OSPF Interface 1 # /cfg/l3/ospf/if 2
>> OSPF Interface 2 # aindex 1
>> OSPF Interface 2 # enable 1
12. Configure host routes. One host route is needed for each virtual server on Alteon 1. Since virtual
server 10.10.10.1 is preferred for Alteon 1, its host route has a low cost. Because virtual server
10.10.10.2 is used as a backup in case Alteon 2 fails, its host route has a high cost.
Note: You do not need to enable redistribution (
virtual server routes as host routes.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Enable OSPF on Alteon 1)
(Select menu for area index 0)
(Set the ID for backbone area 0)
(Define backbone as transit type)
(Enable the area)
(Select menu for area index 1)
(Set the ID for stub area 1)
(Define area as stub type)
(Enable the area)
(Select OSPF menu for IP interface 1)
(Attach network to backbone index)
(Enable the backbone interface)
(Select OSPF menu for IP interface 2)
(Attach network to stub area index)
(Enable the stub area interface)
/cfg/l3/ospf/redist
Open Shortest Path First (OSPF)
) if you configure
161