Radware Alteon Application Manual page 643

3. Enable WAN link load balancing.
>> # /cfg/slb/linklb
>> # /cfg/slb/linklb/group 100
>> # /cfg/slb/linklb/ena
4. Enable Direct Access Mode (DAM). Typically, you have two or more virtual server IP addresses
representing the same real service. On the return path, DAM ensures that the real server IP
address is mapped to the correct virtual IP address.
>> # /cfg/slb/adv/direct ena
For information about DAM, refer to
Step 4a (Outbound Traffic)—Configure the Client Ports
Configure the redirection filter and enable the filter for link load balancing. This is required to
translate (NAT) the client IP address to the proxy IP address.
1. Define the WAN link load balancing redirection filter.
>> # /cfg/slb/filt 100
>> Filter 100# ena
>> Filter 100# action redir
>> Filter 100# group 100
2. Enable WAN link load balancing for the redirection filter.
>> Filter 100# adv/redir
>> Filter 100 Redirection Advanced# linklb ena
3. Add the link load balancing filter 100 to the outbound client port.
>> # /cfg/slb/port 5
>> SLB Port 5# add 100
>> SLB Port 5# filt ena
4. If you are configuring link load balancing for outbound traffic only, then go to
Save Your Changes, page
balancing of inbound traffic only.
Step 4b (Inbound Traffic)—Configure Server Ports
For each real server connected to Alteon, assign a real server number, specify its IP address, and
enable the real server. Define a real server group and add the real server to the group.
1. Configure real server and create a group.
>> # /cfg/slb/real3/rip 1.1.1.2
>> Real server 3# ena
>> # /cfg/slb/group 3
>> Real server Group 3# add 3
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
Direct Access Mode, page
645. The remaining steps in this procedure are used for load
WAN Link Load Balancing
(Select the link load balancing menu)
(Specify the ISP group of real servers)
(Enable link load balancing)
200.
(Select the ISP group of real servers)
(Select port 5)
(Add filter 100 to port 5)
(Enable the filter)
Step 7—Apply and
(Define IP address for real server 3)
(Enable real server 3)
(Define a group)
(Add real server 3)
643