Radware Alteon Application Manual page 779

>> # /cfg/bwm/pol 1
>> Policy 1# hard 10M
>> Policy 1# soft 5M
>> Policy 1# resv 1M
4. Configure BWM contract 1. Each contract must have a unique number from 1 to 1024.
>> Policy 1# /cfg/bwm/cont 1
5. Assign the bandwidth policy 1 to Contract 1.
>> BWM Contract 1# pol 1
6. Enable Contract 1.
>> BWM Contract 1# ena
7. Select Bandwidth Policy 2.
>> BWM Contract 1# /cfg/bwm/pol 2
8. Set the hard, soft, and reserved rate limits for this policy, in Mbps.
>> Policy 2# hard 20
>> Policy 2# soft 15
>> Policy 2# resv 10
9. On Alteon, select BWM Contract 2.
>> Policy 2# /cfg/bwm/cont 2
10. Assign Bandwidth Policy 2 to Contract 2. Each BWM contract must be assigned a bandwidth
policy.
>> BWM Contract 2# pol 2
11. Enable Contract 2.
>> BWM Contract 2# ena
12. As described in step 7
30, 25, and 20 Mbps respectively. Then create Contract 3 and apply Policy 3 to this contract.
13. Configure Policy 4 with hard, soft, and reserved limits of 40, 35, and 30 Mbps respectively. Then
create Contract 4 and apply Policy 4 to this contract.
14. Configure BWM Contract Group 1 and add all four contracts to this group.
>> /cfg/bwm/group 1
>> BW Group 1# add 1
Contract 1 added to group 1.
>> BW Group 1# add 2
Contract 2 added to group 1.
>> BW Group 1# add 3
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
through step 11, configure Policy 3 with hard, soft, and reserved limits of
Bandwidth Management
(Select BWM Policy 1)
(Set "never exceed" rate)
(Set desired bandwidth rate)
(Set committed information rate)
(Set "never exceed" rate)
(Set desired bandwidth rate)
(Set committed information rate)
(Select Contract Group 1)
(Add Contract 1 to Group 1)
(Add Contract 2 to Group 1)
(Add Contract 3 to Group 1)
779