Radware Alteon Application Manual page 303

— Configure for RADIUS services 1812, 1813, and 1645.
Note: If the application is not recognized by the port, set the application to basic-slb.
>> # /cfg/slb/virt <number> /service <name|number> /protocol udp
Note: The RADIUS service number specified on Alteon must match with the service specified
on the server.
2. Configure Alteon for basic SLB.
>> # /cfg/slb/on
3. Configure IP addresses for the RADIUS/WAP gateways.
>> # /cfg/slb/real 1/rip 1.1.1.100
>> Real server 1# ena
>> # /cfg/slb/real 2/rip 2.2.2.100
>> Real server 2# ena
>> # /cfg/slb/real 3/rip 3.3.3.100
>> Real server 3# ena
4. Create a group to load balance the WAP gateways.
>> # /cfg/slb/group 100
>>Real Server Group 100# add 1
>>Real Server Group 100# add 2
>>Real Server Group 100# add 3
5. Enable the external notification from the WAP gateway to add and delete session requests if you
are using static session via TPCP.
>> # cfg/slb/adv/tpcp ena
6. Enable TPCP for adding and deleting WAP sessions.
>> # cfg/slb/wap/tpcp ena
7. Apply and save your configuration.
>> WAP Options# apply
>> WAP Options# save
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Define address for WAP Gateway1)
(Enable Real Server 1)
(Define address for WAP Gateway 2)
(Enable Real Server 2)
(Define address for WAP Gateway 3)
(Enable Real Server 3)
(Define a group)
(Add Real Server 1)
(Add Real Server 2)
(Add Real Server 3)
Load Balancing Special Services
303