Radware Alteon Application Manual page 541

2. Copy and paste the entire contents of the script to a text file. The first and last lines of the file
must be written as shown in the following example:
script start "Alteon Application Switch" 4
/* Configuration dump taken
/* Version 0.0.0,
:
:
script end /**** DO NOT EDIT THIS LINE!
>> Configuration#
3. Edit the text file that you just created as follows:
— Change all the IP interface addresses for Alteon 2. Otherwise, this results in duplicate IP
addresses in the network. In this example, change the last octet in all the IP interfaces from
.251 to .252.
/c/l3/if 1
addr 10.0.1.252
— Change the synchronization peer Alteon to use the IP address of Alteon 1. In this example,
change the last octet from .252 (denoting Alteon 2), to .251 (Alteon 1).
/c/slb/sync/peer 1
ena
addr 172.16.2.251
— Change the virtual router priority from 100 to 101. This indicates that Alteon 2 is the backup
for now.
/c/l3/vrrp/group
:
prio 101
4. Save the changes to the text file as Customer-Name_backup_config and load it onto a TFTP
server.
5. Begin a Telnet session for the second Alteon. Delete any existing configuration on it by resetting
it to factory settings, using the following command:
>> Main # /boot/conf factory/reset
A confirmation message displays. Do one of the following:
— Enter y to save changes and restart.
— Enter n to ignore changes and cancel restart.
Note: If you are prompted to use the step-by-step configuration process when you log in,
Alteon is set to the factory defaults. When prompted, enter No.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
1:52:02 Fri Feb
Base MAC address 00:0e:40:32:7c:00
/**** DO NOT EDIT THIS LINE!
6, 2004
High Availability
541