Radware Alteon Application Manual page 526

Alteon Application Switch Operating System Application Guide
High Availability
To configure Layer 3 virtual router settings for services
1. On the active Alteon, configure each service.
For example, for an HTTP service:
>> Main # /cfg/slb/virt 1
>> Main # /cfg/slb/virt 1/ena
>> Main # /cfg/slb/virt 1/vip 10.10.10.200
>> Main # /cfg/slb/virt 1/service 80 http
2. On the active Alteon, configure a different virtual router for each service.
>> Main # /cfg/l3/vrrp/on
>> Main # /cfg/l3/vrrp/vr 4
>> Main # /cfg/l3/vrrp/vr 4/ena
>> Main # /cfg/l3/vrrp/vr 4/vrid 55
>> Main # /cfg/l3/vrrp/vr 4/if 1
>> Main # /cfg/l3/vrrp/vr 4/prio 101
>> Main # /cfg/l3/vrrp/vr 4/addr 10.10.10.200
3. On the standby Alteon, copy these active Alteon settings, but lower the priority of each virtual
router.
>> Main # /cfg/l3/vrrp/on
>> Main # /cfg/l3/vrrp/vr 4
>> Main # /cfg/l3/vrrp/vr 4/ena
>> Main # /cfg/l3/vrrp/vr 4/vrid 55
>> Main # /cfg/l3/vrrp/vr 4/if 1
>> Main # /cfg/l3/vrrp/vr 4/prio 100
>> Main # /cfg/l3/vrrp/vr 4/addr 10.10.10.200
526
(Select the virtual server)
(Enable the virtual server)
(Set the virtual server virtual IP)
(Specify the service)
(Enable VRRP)
(Specify the virtual router number for
the service)
(Enable the virtual router)
(Set the virtual router ID)
(Select a device IP interface)
(Set the priority bias for the virtual
router)
(Set the virtual server IP address)
(Enable VRRP)
(Specify the virtual router number for
the service)
(Enable the virtual router)
(Set the virtual router ID)
(Select a device IP interface)
(Set the priority bias for the virtual
router)
(Set the virtual server IP address)
Document ID: RDWR-ALOS-V2900_AG1302