Radware Alteon Application Manual page 694

Alteon Application Switch Operating System Application Guide
Virtual Private Network Load Balancing
To configure the clean-side Alteon CA
1. Turn off BOOTP.
>> # /cfg/sys/bootp dis
2. Define and enable VLAN 2 for ports 25, and 26.
>> # /cfg/l2/vlan 2/ena/def 25 26
3. Turn off the Spanning Tree Protocol (STP)
>> # /cfg/l2/stg/off
4. Define the clean-side IP interfaces. Create one clean-side IP interface on a different subnet for
each VPN device being load balanced.
>> #/cfg/l3/if 1 ena
>> IP Interface 1# mask 255.255.0
>> IP Interface 1# addr 30.9.0.10
>> IP Interface 1 # vlan 1
>> IP Interface 1 #/ cfg/13/if 2/ena
>> IP Interface 2 # mask 255.255.255.0
>> IP Interface 2 # addr 20.0.0.10
>> IP Interface 2 # vlan 2
>> IP Interface 2 # /cgf/13/if 3/ena
>> IP Interface 3# mask 255.255.255.
>> IP Interface 3# addr 20.0.0.11
>> IP Interface 3# vlan 2
5. Configure routes for each of the IP interfaces you configured in
gateways. One static route for redirection is required for each VPN device being load balanced.
>>#/cfg/l3/route
>> IP Static Route# add 10.0.0.10
>> IP Static Route# 255.255.255.255
>> IP Static Route# 20.0.0101
>> IP Static Route# 2
>> IP Static Route# add 10.0.0.11
>> IP Static Route# 255.255.255.255
>> IP Static Route# 20.0.0102
>> IP Static Route# 3
694
(Select IP Interface 1 and enable)
(Set subnet mask for Interface 1)
(Set IP address for Interface 1)
(For VLAN 1)
(Select IP Interface 2 and enable)
(Set subnet mask for Interface 2)
(Set IP address for Interface 2)
(For VLAN 2)
(Select IP Interface 3 and enable)
(Set subnet mask for Interface 3)
(Set IP address for Interface 3)
(For VLAN 2)
step 4 using the VPN devices as
(Static route destination IP
address)
(Destination subnet mask)
(Enter gateway IP address)
(For Interface 2)
(Enter destination IP address)
(Destination subnet mask)
(Enter gateway IP address)
(For Interface 3)
Document ID: RDWR-ALOS-V2900_AG1302