Radware Alteon Application Manual page 726

Alteon Application Switch Operating System Application Guide
Global Server Load Balancing
>> # /cfg/l2/vlan 103/name internet
>> VLAN 103# add 3
Port 3 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 103 [y/n]: y
Current ports for VLAN 103:
Pending new ports for VLAN 103:
Current status: disabled
New status: enabled
3. Define an IP interface to the Internet.
>> # /cfg/l3/if 103
>> IP Interface 103# addr 43.10.10.3
>> IP Interface 103# mask 255.255.255.0
>> IP Interface 103# ena
>> IP Interface 103# vlan 103
4. Define the default gateway.
>> IP Interface 103# /cfg/l3/gw 1
>> Default gateway 1# addr 43.10.10.103
>> Default gateway 1# ena
5. Apply and save the configuration.
>> # apply
>> # save
6. Configure the local DNS server to recognize the local GSLB device as the authoritative name
server for the hosted services.
Determine the domain name that will be distributed to both sites and the hostname for each
distributed service. In this example, the Tokyo DNS server is configured to recognize 43.10.10.3
(the IP interface of the Tokyo GSLB device) as the authoritative name server for
"www.gslb.example.com."
To configure the Tokyo site for GSLB
Following the similar procedure described for San Jose (see
page 717), configure the Tokyo site as follows:
1. On the Tokyo Alteon, turn on SLB and GSLB.
>> # /cfg/slb
>> SLB# on
>> # /cfg/slb/gslb
>> Global SLB# on
726
(VLAN 102 for Internet)
(Add Port 3 to VLAN 103)
empty
3
(Select IP Interface 103)
(Assign IP address for the
interface)
(Assign network mask)
(Enable IP Interface 103)
(Assign interface to VLAN 103)
(Select Default Gateway 1)
(Assign IP address for the gateway)
(Enable Default Gateway 1)
To configure the San Jose Site for GSLB,
(Select the SLB Menu)
(Activate SLB for Alteon)
(Select the GSLB Menu)
(Activate GSLB for Alteon)
Document ID: RDWR-ALOS-V2900_AG1302