Radware Alteon Application Manual page 680

Alteon Application Switch Operating System Application Guide
Firewall Load Balancing
4. Configure the VRRP peer on the primary dirty-side Alteon.
>> # /cfg/slb/sync
>> # prios d
>> # peer 1
>> # ena
>> # addr 195.1.1.11
5. Apply and save your configuration changes.
>> # apply
>> # save
6. Synchronize primary and secondary dirty-side Alteons for the VRRP configuration.
>> # /oper/slb/sync
Complete Primary Clean-Side Alteon Configuration
The following is an example configuration for a primary clean-side Alteon.
To complete the primary clean-side Alteon configuration
1. Create an FWLB real server group on the primary clean-side Alteon.
A real server group is used as the target for the FWLB redirection filter. Each IP address assigned
to the group represents a return path through a different firewall. In this case, since two
firewalls are used, two addresses are added to the group. The two addresses are the interfaces
of the dirty-side Alteon, and are configured as if they are real servers.
Note: IF 2 is used on all Alteons whenever routing through the top firewall, and IF 3 is used on
all Alteons whenever routing through the lower firewall.
>> # /cfg/slb
>> # on
>> # real 1
>> # rip 10.10.2.1
>> # ena
>> # /cfg/slb/real 2
>> # rip 10.10.2.2
>> # ena
>> # /cfg/slb/group 1
>> # add 1
>> # add 2
>> # metric hash
680
(IF2 of the primary dirty-side
Alteon)
(IF2 of the primary dirty-side
Alteon)
Document ID: RDWR-ALOS-V2900_AG1302