Radware Alteon Application Manual page 546

Alteon Application Switch Operating System Application Guide
High Availability
5. Configure virtual server routers 2 and 4.
These virtual routers have the same IP addresses as the virtual server IP address. This is how
Alteon recognizes that these are virtual service routers (VSRs).
For an active-standby configuration, sharing is disabled.
>> Main # /cfg/l3/vrrp/vr 2
>> VRRP Virtual Router 2# vrid 2
>> VRRP Virtual Router 2# addr 205.178.13.226
>> VRRP Virtual Router 2# if 2
>> VRRP Virtual Router 2# share dis
>> VRRP Virtual Router 2# ena
>> Main # /cfg/l3/vrrp/vr 4
>> VRRP Virtual Router 4# vrid 4
>> VRRP Virtual Router 4# addr 205.178.13.300
>> VRRP Virtual Router 4# if 4
>> VRRP Virtual Router 4# share dis
>> VRRP Virtual Router 4# ena
6. Add virtual routers 1 and 2 to the Vrgroup 1.
>> Main# /cfg/l3/vrrp/vrgroup 1
>> VRRP Virtual Router Vrgroup 1# add 1
>> VRRP Virtual Router Vrgroup 1# add 2
>> VRRP Virtual Router Vrgroup 1# ena
>> VRRP Virtual Router Vrgroup 1# track
>> VRRP Vrgroup 1 Priority Tracking# ports ena
7. Add virtual routers 3 and 4 to switch-based Vrgroup 2.
>> Main# /cfg/l3/vrrp/vrgroup 2
>> VRRP Virtual Router Vrgroup 2# add 3
>> VRRP Virtual Router Vrgroup 2# add 4
>> VRRP Virtual Router Vrgroup 2# ena
>> VRRP Virtual Router Vrgroup 2# track
>> VRRP Vrgroup 2 Priority Tracking# l4ports ena
8. Disable synchronizing of priority on Alteon 1.
The priorities should not be synchronized between the two Alteons. The priority for each vrgroup
will change based on the tracking parameters configured in
>> Main # /cfg/slb/sync prios disable
546
(Select Virtual Router 2)
(Set the virtual router ID)
(Assign VR IP address)
(Assign virtual router interface)
(Disable sharing of interfaces)
(Enable Virtual Router 2)
(Select Virtual Router 4)
(Set virtual router ID)
(Assign VR IP address)
(Assign virtual router interface)
(Disable sharing of interfaces)
(Enable virtual router 4)
(Add virtual router 1—the VIR)
(Add virtual router 2—the VSR)
(Select the Priority Tracking
menu)
(Track on physical ports)
(Add Virtual Router 1)
(Add Virtual Router 2)
(Select the Priority Tracking
menu)
(Track on layer 4 ports)
step 6 and step 7.
Document ID: RDWR-ALOS-V2900_AG1302