Radware Alteon Application Manual page 539

3. Turn off spanning tree.
>> Main # /cfg/l2/stg 1/off
>> Spanning Tree Group 1# apply
>> Spanning Tree Group 1# save
4. Configure the IP addresses for each VLAN.
>> Main # /cfg/l3/
>> IP Interface 1# /cfg/l3/if 2
>> IP Interface 2# ena
>> IP Interface 2# addr 192.168.1.251
>> IP Interface 2# vlan 192
>> IP Interface 2# /cfg/l3/if 3
>> IP Interface 3# ena
>> IP Interface 3# addr 172.16.2.251
>> IP Interface 3# vlan 172
To configure virtual router redundancy
1. Configure virtual routers for the server, client, and interswitch link traffic.
>> Main #/cfg/l3/vrrp/vr 2
>> VRRP Virtual Router 2# ena
>> VRRP Virtual Router 2# vrid 2
>> VRRP Virtual Router 2# if 2
>> VRRP Virtual Router 2# addr 192.168.1.250
>> Main # /cfg/l3/vrrp/vr 3
>> VRRP Virtual Router 3# ena
>> VRRP Virtual Router 3# vrid 3
>> VRRP Virtual Router 3# if 3
>> VRRP Virtual Router 3# addr 172.16.2.250
2. From the VRRP menu, enable VRRP group mode and hot standby on all connected ports except
the interswitch link.
>> Main # /cfg/l3/vrrp/on
>> Virtual Router Redundancy Protocol# hotstan ena
>> Virtual Router Redundancy Protocol# group ena
>> Virtual Router Redundancy Protocol# if 3
>> VRRP Virtual Router Group# apply
>> VRRP Virtual Router Group# save
Note: When you enable hot standby for a vrgroup, the currently set priority for the vrgroup is
increased by 2.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Disable STG group)
(Make your changes active)
(Save for restore after reboot)
(IP Interface 2: client traffic)
(IP Interface 3: interswitch link and
servers)
(Virtual router for client)
(Virtual router for interswitch link
and servers)
(Enable VRRP)
(Enable hot standby)
(Enable VR group)
(Define the tracking interface)
(Make your changes active)
(Save for restore after reboot)
High Availability
539