Radware Alteon Application Manual page 703

Figure 118: Checkpoint Rules for both VPN Devices as seen in the Policy Editor
1. Disconnect the cables (cause failures) to change the available servers that are up
>> # /info/slb/dump
This should change the VRRP preferences. You can view VRRP preferences using the command
.
/info/l3/vrrp
2. Watch for accepted and dropped traffic. In the toolbar, go to Window > Log Viewer.
Note: To help simplify the logs, the health checks are not logged.
To test the VPN
1. Launch the SecuRemote client on the dirty side of the network.
2. Add a new site.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
Virtual Private Network Load Balancing
703