Radware Alteon Application Manual page 696

Alteon Application Switch Operating System Application Guide
Virtual Private Network Load Balancing
8. Configure real servers for health checking VPN devices.
>> # /cfg/slb/real 1/ena
>> Real server 1 # rip 10.0.0.10
>> Real server 1 # /cfg/slb/real 2/ena
>> Real server 2 # rip 10.0.0.11
>> Real server 2 # /cfg/slb/real 3/ena
>> Real server 3 # rip 10.0.0.20
>> Real server 3 # /cfg/slb/real 4/ena
>> Real server 4 # rip 10.0.0.21
9. Configure Real Server group 1, and add Real Servers 1, 2, 3, and 4 to the group.
>> # /cfg/slb/group 1
>> Real server group 1# metric hash
>> Real server group 1 # add 1
>> Real server 1# add 2/add3/add4
10. Configure a filter to enable the transparent load balancing (Return to Source MAC address)
option. This adds an opposite entry in the session table so that the return traffic matches its
source MAC address.
>> # /cfg/slb/filt 20/adv
>> Filter 20 Advanced# rtsrcmac ena
11. Enable filter processing on the server ports so that the responses from the real server are looked
up in the VPN session table.
>> # /cfg/slb/port 1/filt ena
12. When dynamic routing protocols are not used, configure a gateway to the external router.
>> # /cfg/l3/gw 1/addr 192.168.10.50
13. Apply and save the configuration, and reboot Alteon.
>> # apply
>> # save
>> # /boot/reset
To configure the clean-side Alteon CB
1. Turn off BOOTP.
>> # /cfg/sys/bootp dis
696
(Enable SLB for Real Server 1)
(Assign IP address for Real Server 1)
(Enable SLB for Real Server 2)
(Assign IP address for Real Server 2)
(Enable SLB for Real Server 3)
(Assign IP address for Real Server 3)
(Enable SLB for Real Server 4)
(Assign IP address for Real Server 4)
(Configure Real Server Group 1)
(Select SLB hash metric for Group
1)
(Add real servers 1 through 4 to
Group 1)
(Select the Advanced menu for Filter 20)
(Enable Return to Source MAC Address)
Document ID: RDWR-ALOS-V2900_AG1302