Radware Alteon Application Manual page 698

Alteon Application Switch Operating System Application Guide
Virtual Private Network Load Balancing
9. Enable the real server group.
>> Real server 4 # /cfg/slb/group
>> Real server group 1# metric hash
>> Real server group 1# add 1/add 2/add 3/ add 4
10. Configure a filter to enable the transparent load balancing (Return to Source MAC address)
option. This adds an opposite entry in the session table so that the return traffic matches its
source MAC address.
>> # /cfg/slb/filt 20/adv
>> Filter 20 Advanced# rtsrcmac ena
11. Enable filter processing on the server ports so that the response from the real server will be
looked up in VPN session table.
>> SLB port 25# /cfg/slb/port 1 /filt ena
12. Apply and save the configuration, and reboot Alteon.
>> SLB port 25# apply
>> SLB port 25# save
>> SLB port 25# /boot/reset
To configure the dirty-side Alteon DA
1. Turn off BOOTP.
>> # /cfg/sys/bootp dis
2. Define and enable VLAN 2 for ports 25 and 26.
>> # /cfg/l2/vlan 2/ena/def 25 26
3. Turn off the Spanning Tree Protocol (STP).
>> # /cfg/l2/stg/off
4. Configure IP interfaces 1, 2, and 3.
>> # /cfg/l3/if 1/ena/mask 255.255.255.0/addr 192.168.10.10
>> # /cfg/l3/if 2/ena/mask 255.255.255.0/addr 10.0.0.10/vl 2
>> # /cfg/l3/if 3/ena/mask 255.255.255.255/addr 10.0.0.11/vl 2
5. Define static routes for each of the IP interfaces you configured in
as gateways. One static route is required for each VPN device being load balanced.
698
(Select the Advanced menu for Filter 20)
(Enable Return to Source MAC Address)
step 4 using the VPN devices
Document ID: RDWR-ALOS-V2900_AG1302