Radware Alteon Application Manual page 173

6. Define the port settings. In this example, the following ports are being used on Alteon:
Port Host
1 Server A serves SLB requests.
2 Server B serves SLB requests.
3 Server C serves SLB requests.
4 Back-end NFS server provides centralized content for all three real
servers. This port does not require switching features.
5 Client router A connects Alteon to the Internet where client
requests originate.
6 Client router B connects Alteon to the Internet where client
requests originate.
The ports are configured as follows:
>> Virtual server 1# /cfg/slb/port 1
>> SLB port 1# server ena
>> SLB port 1# /cfg/slb/port 2
>> SLB port 2# server ena
>> SLB port 1# /cfg/slb/port 3
>> SLB port 3# server ena
>> SLB port 5# /cfg/slb/port 5
>> SLB port 5# client ena
>> SLB port 6# /cfg/slb/port 6
>> SLB port 6# client ena
7. Enable, apply, and verify the configuration.
>> SLB port 6# /cfg/slb
>> Layer 4# on
>> Layer 4# apply
>> Layer 4#cur
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
8. Save your new configuration changes.
>> Layer 4# save
Note: You must apply any changes in order for them to take effect, and you must save
changes if you want them to remain in effect after reboot.
9. Check the SLB information.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
Table 19: Web Host Example: Port Usage
Server Load Balancing
(Select physical port 1)
(Enable server processing on port 1)
(Select physical port 2)
(Enable server processing on port 2)
(Select physical port 3)
(Enable server processing on port 3)
(Select physical port 5)
(Enable client processing on port 1)
(Select physical port 6)
(Enable server processing on port 6)
(Select the SLB Menu)
(Turn SLB on)
(Make your changes active)
(View current settings)
L4 Processing
Server
Server
Server
None
Client
Client
173