Radware Alteon Application Manual page 736

Alteon Application Switch Operating System Application Guide
Global Server Load Balancing
In the client proximity table, the static client proximity entries are set to Site C as the closest.
Note: When the closest site is down, the client is redirected to the next closest site. In
125 - GSLB Client Proximity Site with HTTPS Service, page
is down, it sends an HTTP redirect message with Site B VIP address/domain name.
To configure Site A
1. Enable SLB, Direct Access Mode (DAM), and GSLB globally.
>> # /cfg/slb/on
>> # /cfg/slb/adv/direct ena
>> # /cfg/slb/gslb/on
2. Set up DSSP version 4 for client proximity updates.
>> # /cfg/slb/gslb/version 4
3. Set up local real server. For example, the real server IP address is 10.10.10.12.
>> # /cfg/slb/real 1
ena
ipver v4
rip 10.10.10.12
4. Set up remote real servers for Site B and Site C.
>> # /cfg/slb/real 2/ena
ipver v4
rip 174.14.70.200
>> # /cfg/slb/real 2/adv
remote ena
>> # /cfg/slb/real 3/ena
ipver v4
rip 201.2.2.100
>> # /c/slb/real 3/adv remote ena
5. Configure SLB Group 1 with content-based health check.
>> # /cfg/slb/group 1
ipver v4
health http
content "index.html"
add 1
736
735, if Site A determines that Site C
(Enable SLB)
(Enable DAM)
(Enable GSLB)
(Assign local real server IP)
(Set the DSSP version to 4)
(Assign a real server to Site B)
(Enable remote the real server for
Site B)
(Assign a real server to Site C)
(Enable remote the real server for
Site C)
(Configure SLB Group 1)
(Enable HTTP-based health check)
(Configure content-based health
check for Group 1)
(Add Real Server 1)
Document ID: RDWR-ALOS-V2900_AG1302
Figure