Radware Alteon Application Manual page 385

Figure 60: Static NAT Example
To configure static NAT
>> # /cfg/slb/filt 10
>> Filter 10# action nat
>> Filter 10# nat source
>> Filter 10# sip 10.10.10.0
>> Filter 10# smask 255.255.255.0
>> Filter 10# dip 205.178.13.0
>> Filter 10# dmask 255.255.255.0
>> Filter 10# ena
>> Filter 10# adv/proxyadv/proxy disable
>> Enter new NAT IP address:
>> Filter 10 Advanced# /cfg/slb/filt 11
>> Filter 11# action nat
>> Filter 11# nat dest
>> Filter 11# sip 10.10.10.0
>> Filter 11# smask 255.255.255.0
>> Filter 11# dip 205.178.13.0
>> Filter 11# dmask 255.255.255.0
>> Filter 11# ena
>> Filter 11# adv/proxy disable
>> Filter 11 Advanced# /cfg/slb/port 1
>> SLB port 1# add 10
>> SLB port 1# filt enable
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Select the menu for outbound filter)
(Perform NAT on matching traffic)
(Translate source information)
(From the clients private IP address)
(For the entire private subnet range)
(To the public network address)
(For the same subnet range)
(Enable the filter)
(Override any proxy IP settings. Static
NAT is used for this filter.)
(Set the NAT Address)
(Select the menu for inbound filter)
(Use the same settings as outbound)
(Reverse the translation direction)
(Use the same settings as outbound)
(Use the same settings as outbound)
(Use the same settings as outbound)
(Use the same settings as outbound)
(Enable the filter)
(Override any proxy IP settings)
(Select server-side port)
(Add the outbound filter)
(Enable filtering on port 1)
Filtering and Traffic Manipulation
385