Verifying Ospf Configuration - Radware Alteon Application Manual

Alteon Application Switch Operating System Application Guide
Open Shortest Path First (OSPF)
>> OSPF Interface 1 # /cfg/l3/ospf/if 2
>> OSPF Interface 2 # aindex 1
>> OSPF Interface 2 # enable
9. Configure host routes. Host routes are configured just like those on Alteon 1, except their costs
are reversed. Since virtual server 10.10.10.2 is preferred for Alteon 2, its host route has been
given a low cost. Because virtual server 10.10.10.1 is used as a backup in case Alteon 1 fails, its
host route has been given a high cost.
>> OSPF Interface 2 # /cfg/l3/ospf/host 1
>> OSPF Interface 1 # addr 10.10.10.1
>> OSPF Host Entry 1 # aindex 0
>> OSPF Host Entry 1 # cost 100
>> OSPF Host Entry 1 # enable
>> OSPF Host Entry 1 # /cfg/l3/ospf/host 2
>> OSPF Host Entry 2 # addr 10.10.10.2
>> OSPF Host Entry 2 # aindex 0
>> OSPF Host Entry 2 # cost 2
>> OSPF Host Entry 2 # enable
10. Apply and save the configuration changes.
>> OSPF Host Entry 2 # apply
>> OSPF Host Entry 2 # save

Verifying OSPF Configuration

Use the following commands to verify the OSPF configuration:
• /info/l3/ospf/general
• /info/l3/ospf/nbr
• /info/l3/ospf/dbase/dbsum
• /info/l3/ospf/route
• /stats/l3/route
Refer to the Alteon Application Switch Operating System Command Reference for information on
these commands.
164
(Select OSPF menu for IP interface 2)
(Attach network to stub area index)
(Enable the stub area interface)
(Select menu for host route 1)
(Set IP address same as virtual server
1)
(Inject host route into backbone area)
(Set high cost for use as backup path)
(Enable the host route)
(Select menu for host route 2)
(Set IP address same as virtual server
2)
(Inject host route into backbone area)
(Set low cost for primary path)
(Enable the host route)
(Global command to apply all changes)
(Global command to save all changes)
Document ID: RDWR-ALOS-V2900_AG1302