Radware Alteon Application Manual page 654

Alteon Application Switch Operating System Application Guide
WAN Link Load Balancing
2. Configure an entry for each ISP and specify the virtual and real server (ISP router).
>> Domain record 1# entry 1/ena
>> Virt Real Mapping virt 1
>> Virt Real Mapping# real 1
>> Domain record 1# entry 2/ena
>> Virt Real Mapping# virt 2
>> Virt Real Mapping# real 2
3. Configure the domain record for xyz.com.
>> # /cfg/slb/linklb/drecord 2
>> Domain Record 2# ena
>> Domain record 2# domain xyz.com
4. Configure an entry for each ISP and specify the virtual and real server (ISP router).
>> Domain record 2# entry 1/ena
>> Virt Real Mapping# virt 3
>> Virt Real Mapping# real 1
>> Domain record 1# entry 2/ena
>> Virt Real Mapping# virt 4
>> Virt Real Mapping# real 1
Step 7—Apply and Save Your Changes
You must apply your changes in order for them to take effect, and you must save changes if you
want them to remain in effect after reboot.
1. Apply and verify the configuration.
>> Layer 4# apply
>> Layer 4# cur
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
2. Save your new configuration changes.
>> Layer 4# save
3. Check the load balancing information.
>> Layer 4# /info/slb/dump
4. Check that all load balancing parameters are working as expected. If necessary, make any
appropriate configuration changes and then check the information again.
654
(Define entry for ISP 1)
(Select virtual server 1 for ISP 1)
(Select real server for ISP 1)
(Define entry for ISP 2)
(Select virtual server 2 for ISP 2)
(Select real server for ISP 2)
(Select the domain record menu)
(Enable the domain)
(Define the domain name)
(Define entry for ISP 1)
(Select virtual server 3 for ISP 1)
(Select real server for ISP 1)
(Define entry for ISP 2)
(Select virtual server 4 for ISP 2)
(Select real server for ISP 2)
Document ID: RDWR-ALOS-V2900_AG1302