Radware Alteon Application Manual page 681

Note: The clean-side Alteon must use the same metric as defined on the dirty side. For
information on using metrics other than hash, see
2. Create an SLB real server group on the primary clean-side Alteon to which traffic will be load
balanced.
The external clients are configured to connect to HTTP services at a publicly advertised IP
address. The servers on this network are load balanced by a virtual server on the clean-side
Alteon. SLB options are configured as follows:
>> # /cfg/slb
>> # real 20
>> # rip 10.10.4.20
>> # ena
>> # /cfg/slb.real 21
>> # rip 10.10.4.21
>> # ena
>> # /cfg/slb/real 22
>> # rip 10.10.4.22
>> # ena
>> # /cfg/slb/group 2
>> # add 20
>> # add 21
>> # add 22
>> # metric leastconns
>> # /cfg/slb/virt 1
>> # vip 10.10.4.100
>> # service http
>> # group 2
>> # ena
>> # /cfg/slb/port/26/server ena
>> # /cfg/slb/port/25/client ena
>> # /cfg/slb/port/28/client ena
Note: The virtual server IP address configured in this step will also be configured as a Virtual
Server Router (VSR) when VRRP is configured in a later step.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
Free-Metric FWLB, page
(Select the SLB menu)
(Select Real Server 20)
(Set IP address of Real Server 20)
(Enable)
(Select Real Server 21)
(Set IP address of Real Server 21)
(Enable)
(Select Real Server 22)
(Set IP address of Real Server 22)
(Enable)
(Select Real Server group 2)
(Add the Real Servers to the group)
(Select least connections as the
load-balancing metric)
(Select the Virtual Server 1 menu)
(Set the virtual server IP address)
(Select HTTP for load balancing)
(Add Real Server Group 2)
(Enable the virtual server)
(Enable server processing on the
port connected to the real servers)
(Enable client processing on the port
connected to the firewall)
(Enable client processing on the
interswitch connection)
Firewall Load Balancing
683.
681