Radware Alteon Application Manual page 157

Figure 23: Summarizing Routes Example
Note: You can specify a range of addresses to prevent advertising by using the hide option. In
this example, routes in the range 36.128.200.0 through 36.128.200.255 are kept private.
1. Configure IP interfaces for each network which is attached to OSPF areas.
>> OSPF Virtual Link 1 # aindex 1
>> IP Interface 1 # addr 10.10.7.1
>> IP Interface 1 # mask 255.255.255.0
>> IP Interface 1 # ena
>> IP Interface 1 # /cfg/l3/if 2
>> IP Interface 2 # addr 36.128.192.1
>> IP Interface 2 # mask 255.255.192.0
>> IP Interface 2 # ena
2. Enable OSPF.
>> IP Interface 2 # /cfg/l3/ospf/on
3. Define the backbone.
>> Open Shortest Path First # aindex 0
>> OSPF Area (index) 0 # areaid 0.0.0.0
>> OSPF Area (index) 0 # type transit
>> OSPF Area (index) 0 # enable
4. Define the stub area.
>> OSPF Area (index) 0 # /cfg/l3/ospf/aindex
1
>> OSPF Area (index) 1 # areaid 0.0.0.1
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Select menu for IP interface 1)
(Set IP address on backbone network)
(Set IP mask on backbone network)
(Enable IP interface 1)
(Select menu for IP interface 2)
(Set IP address on stub area network)
(Set IP mask on stub area network)
(Enable IP interface 2)
(Enable OSPF on Alteon)
(Select menu for area index 0)
(Set the ID for backbone area 0)
(Define backbone as transit type)
(Enable the area)
(Select menu for area index 1)
(Set the area ID for OSPF area 1)
Open Shortest Path First (OSPF)
157