Radware Alteon Application Manual page 152

Alteon Application Switch Operating System Application Guide
Open Shortest Path First (OSPF)
>> Open Shortest Path First # aindex 0
>> Open Area (index) 0 # areaid 0.0.0.0
>> Open Area (index) 0 # type transit
>> OSPF Area (index) 0 # enable
4. Define the stub area.
>> OSPF Area (index) 0 # /cfg/l3/ospf/aindex 1
>> OSPF Area (index) 1 # areaid 0.0.0.1
>> OSPF Area (index) 1 # type stub
>> OSPF Area (index) 1 # enable
5. Attach the network interface to the backbone.
>> OSPF Area 1 # /cfg/l3/ospf/if 1
>> OSPF Interface 1 # aindex
>> OSPF Interface 1 # enable
6. Attach the network interface to the stub area.
>> OSPF Interface 1 # /cfg/l3/ospf/if 2
>> OSPF Interface 2 # aindex 1
>> OSPF Interface 2 # enable
7. Apply and save the configuration changes.
>> OSPF Interface 2 # apply
>> OSPF Interface 2 # save
Example 2: Virtual Links
In the example shown in
connected to the backbone as is usually required. Instead, area 2 is connected to the backbone
through a virtual link through area 1. The virtual link must be configured at each endpoint.
152
Figure 22 - Virtual Links Example, page
(Select menu for area index 0)
(Set the ID for backbone area 0)
(Define backbone as transit type)
(Enable the area)
(Select menu for area index 1)
(Set the area ID for OSPF area 1)
(Define area as stub type)
(Enable the area)
(Select OSPF menu for IP interface 1)
(Attach network to backbone index)
(Enable the backbone interface)
(Select OSPF menu for IP interface 2)
(Attach network to stub area index)
(Enable the stub area interface)
(Global command to apply all changes)
(Global command to save all changes)
153, area 2 is not physically
Document ID: RDWR-ALOS-V2900_AG1302