Radware Alteon Application Manual page 58

Alteon Application Switch Operating System Application Guide
Accessing Alteon
>> NTP Server# prisrv
Current NTP server address: 0.0.0.0
Enter new NTP server address:
3. Set the IP address of the secondary NTP server. This is the NTP server that Alteon would
synchronize with in instances where the primary server is not available. You can configure an
IPv4 or IPv6 address for the NTP server.
>> NTP Server# secsrv
Current NTP server address: 0.0.0.0
Enter new NTP server address:
4. Set the re-synchronization interval. The re-synchronization interval is the amount of time Alteon
waits between queries to the NTP server.
>> NTP Server# intrval
Current resync interval (minutes): 1440
Enter new resync interval (minutes) [1-44640]: 2000
5. Optionally, set the NTP time zone offset. The NTP time zone offset from Greenwich Mean Time
defaults to the setting configured when the Alteon time zone was set. If this has not been done,
or you want to override the current value, do the following:
>> NTP Server# tzone
Current GMT timezone offset:
Enter new GMT timezone offset in hours [-12:00, +12:00]:
6. Enable NTP functionality.
>> NTP Server# onCurrent status: OFF
New status: ON
Note: To disable NTP functionality, use the off command.
58
192.168.249.13
192.168.249.45
-8:00
Document ID: RDWR-ALOS-V2900_AG1302
+4:00