Radware Alteon Application Manual page 398

Alteon Application Switch Operating System Application Guide
Filtering and Traffic Manipulation
Command Menu
/cfg/slb/filt <filter Number> /adv/
8021p
/cfg/slb/filt <filter Number> /adv/
proxyadv
/cfg/slb/filt <filter Number> /adv/
redir
/cfg/slb/filt <filter Number> /adv/
security/ratelim
The following example creates two IPv6 filters for Port 1. Filter 1 allows the exchange Neighbors
Solicitation packets, and Filter 2 allows the movement of bridged HTTP traffic.
Example IPv6 Filtering Example
1. Globally enable Layer 4 load balancing. Layer 4 load balancing must be enabled to allow filter
processing to take place.
>> Main# /cfg/slb/on
2. Create Filter 1 to allow the passage of Neighbors Solicitation packets.
>> Main# /cfg/slb/filt 1/ena
>> Filter 1# action allow
>> Filter 1# ipver v6
>> Filter 1# sip 2001:0:0:0:0:0:0:0
>> Filter 1# smask 64
>> Filter 1# dip ff00:0:0:0:0:0:0:0
>> Filter 1# dmask 8
>> Filter 1# vlan any
3. Create Filter 2 to allow the movement of bridged HTTP traffic.
s
>> Main# /cfg/slb/filt 2/ena
>> Filter 2# action allow
>> Filter 2# ipver v6
>> Filter 2# sip 2001:0:0:0:0:0:0:1
>> Filter 2# smask 128
>> Filter 2# dip 2001:0:0:0:0:0:0:8
>> Filter 2# dmask 128
>> Filter 2# proto tcp
>> Filter 2# sport any
398
Table 34: IPv6 Filter Configuration Commands
Supported Commands
All 802.1p menu commands.
All Proxy menu commands.
All Redirection menu commands.
All Rate Limiting menu commands.
(Enable Filter 1)
(Specify an ALLOW filter)
(Specify an IPv6 filter)
(Specify source IP)
(Specify IPv6 source prefix)
(Specify destination IP)
(Specify IPv6 destination prefix)
(Specify VLAN settings)
(Enable Filter 2)
(Specify an ALLOW filter)
(Specify an IPv6 filter)
(Specify source IP)
(Specify IPv6 source prefix)
(Specify destination IP)
(Specify IPv6 destination prefix)
(Specify filter protocol)
(Specify source port)
Document ID: RDWR-ALOS-V2900_AG1302