Radware Alteon Application Manual page 627

/cfg/bwm/cont <x>/mononly ena
The following is an example set of monitoring messages that are displayed on the console:
10:10.1.1.10:5060->10.1.1.21 mrid 1 from_has_bob
cid 54A5E6ED-B154-4A22-A59B-E
f sam <sip:sam@ocs2007.com>
t <sip:bob@ocs2007.com>
Dependent Mode
You can configure two dependent rules for a rule. When rules contain dependent rules, the rule is
matched only when its dependent rules are matched. It checks only the dependent rules for a
match.
Alteon is in the inspection path until it finds a match. When multiple rules are matched, Alteon takes
the action of the highest severity rule. If the highest severity rule contains dependent rules, and if
the dependent rules are not matched, Alteon takes the action of the next highest severity rule that
does not contain dependent rules. Alteon takes the action of the highest severity rule only when all
its dependent rules are matched.
Configuring the FlexiRules
The following is an example configuration FlexiRules.
To configure FlexiRules
1. Create the rule.
/cfg/slb/layer7/rule <1 to 100>
2. Define the rule.
/cfg/slb/layer7/rule 1/hdrfld
from|to|replyto|via|method|reqline|callid|cseq|contact|expires|contentlen|sdpco
ntent
3. Define the content of the header field name.
/cfg/slb/layer7/rule 1/content bob
4. Define the severity (1 to 5)
/cfg/slb/layer7/rule 1/severity 1
5. Assign contract for this rule (1 to 1024). For information about creating contracts, see
Bandwidth Management, page
/cfg/slb/layer7/rule 1/contract 2
6. Define the message. This message appears in the log when the rule is matched.
/cfg/slb/layer7/rule 1/message "from Bob"
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
761.
Advanced Denial of Service Protection
627