Network Time Protocol - Radware Alteon Application Manual

Please select one of the following time zone regions.
1) Newfoundland Island
2) Atlantic Time - Nova Scotia (most places), NB, W Labrador, E Que-bec & PEI
3) Atlantic Time - E Labrador
4) Eastern Time - Ontario & Quebec - most locations
5) Eastern Time - Thunder Bay, Ontario
6) Eastern Standard Time - Pangnirtung, Nunavut
7) Eastern Standard Time - east Nunavut
8) Eastern Standard Time - central Nunavut
9) Central Time - Manitoba & west Ontario
10) Central Time - Rainy River & Fort Frances, Ontario
11) Central Time - west Nunavut
12) Central Standard Time - Saskatchewan - most locations
13) Central Standard Time - Saskatchewan - midwest
14) Mountain Time - Alberta, east British Columbia & west Saskatchewan
15) Mountain Time - central Northwest Territories
16) Mountain Time - west Northwest Territories
17) Mountain Standard Time - Dawson Creek & Fort Saint John, British
Columbia
18) Pacific Time - west British Columbia
19) Pacific Time - south Yukon
20) Pacific Time - north Yukon
Enter the number of your choice:
5. Apply and save the configuration change.

Network Time Protocol

The Network Time Protocol (NTP) provides the accurate time by synchronizing with a time server on
either an internal or external network. Using NTP ensures that Alteon always has the accurate time
for the various functions that integrate and use time.
To view the current NTP settings
>> Main# /cfg/sys/ntp/cur
Current NTP state: disabled
Current primary NTP server: 0.0.0.0
Current resync interval: 1440 minutes
Current GMT timezone offset: -8:00
Example Configure NTP for an Alteon
1. Access the NTP menu. You can configure an IPv4 or IPv6 address for the NTP server.
>> Main# /cfg/sys/ntp
2. Set the IP address of the primary NTP server. This is the NTP server that Alteon would regularly
synchronize with to adjust its time.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
2
Accessing Alteon
57