Radware Alteon Application Manual page 651

>> # /cfg/slb/real 8/rip 1.1.1.200
>> Real server 8# ena
>> # /cfg/slb/group 4
>> Real server Group 4# add 4
3. Enable filter on server port 1.
Filter is enabled on port 1, because you want Alteon to look up the session table for the
transparent load balancing entry.
>> # /cfg/slb/port 1
>> SLB Port 1# filt ena
4. Enable server processing on port 1.
>> # /cfg/slb/port 1/server ena
5. Configure an allow filter for health checks to occur.
If you have enabled link load balancing filter and server processing on the same port, then an
allow filter must be configured for health checks. The allow filter is activated before the link load
balancing filter, so that the health check traffic does not get redirected to the WAN links.
>> # /cfg/slb/filt 50
>> Filter 50# sip 1.1.1.0
>> Filter 50# smask 255.255.255.0
>> Filter 50# dip 1.1.1.1
>> Filter 50# action allow
>> Filter 50# ena
For more information on health checking, see
6. Add the allow filter 50 to port 1.
>> # /cfg/slb/port 1
>> SLB Port 1# 50
>> SLB Port 1# filt ena
Note: If you are using two Alteons for redundancy, then must add allow filters for VRRP before the
redirection filter. For more information on VRRP, see
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
(Define IP address for xyz.com)
(Enable real server 8)
(Define a group)
(Add real server 8)
(Select port 1)
(Enable the filter)
(From server subnet)
(To IF 1 on Alteon)
Health Checks for Real Servers, page
(Select port 1)
(Add filter 50 to port 1)
(Enable the filter)
High Availability, page
WAN Link Load Balancing
176.
507.
651