Radware Alteon Application Manual page 540

Alteon Application Switch Operating System Application Guide
High Availability
3. Set VRRP tracking for the ports.
If a link on any of the connected ports goes down, the VRRP priority of Alteon decreases and the
backup takes over as the master.
>> Main # /cfg/l3/vrrp
>> VRRP Virtual Router Group# vrid 254
>> VRRP Virtual Router Group# prio 101
>> VRRP Virtual Router Group# track/ports ena
4. Setup the peer Alteon to receive synchronization.
Make sure to disable synchronization of VRRP priorities. The peer Alteon assumes its own
priority based on the VRRP election process and should not acquire the VRRP priority from the
master's configuration. If you want to configure real servers for VRRP hot standby, also enable
synchronization of real server configuration.
>> Main # /cfg/slb/sync/prios d
>> Config Synchronization# peer 1/ena
>> Peer Switch 1# addr 172.16.2.252
5. From the SLB menu, enable a hot standby link on the Layer 4 ports, then enable the interswitch
link on the crosslink.
>> Main # /cfg/slb/port 2
>> SLB port 2# hotstan ena
>> SLB port 2# /cfg/slb/port 3
>> SLB port 3# intersw
Enter VLAN Number: 172
Current inter-switch processing: disabled
Enter new inter-switch processing [d/e]: e
>> SLB port 3# /cfg/slb/port 4
>> SLB port 3# hotstan ena
6. Apply and save changes to the configuration.
>> SLB port 3# apply
>> SLB port 3# save
To prepare a configuration script for Alteon 2
This procedure dumps the configuration script (text dump) from Alteon 1. This configuration will be
modified and loaded onto Alteon 2.
1. Dump Alteon configuration using the following command:
>> Main # /cfg/dump
A script is dumped out.
540
(Set priority at 101 for the
master)
(Do not synchronize VRRP
priorities to the peer Alteon)
(Enable synchronization to the
peer Alteon)
(Set IP address of Alteon 1)
Document ID: RDWR-ALOS-V2900_AG1302