Radware Alteon Application Manual page 308

Alteon Application Switch Operating System Application Guide
Load Balancing Special Services
>>Real Server Group 100# add 2
>>Real Server Group 100# add 3
4. Configure a virtual server.
>> # cfg/slb/virt 1/vip 10.10.10.10
>>Virtual Server 1# ena
5. Configure the services for Virtual Server 1.
Notes
• The RADIUS service number specified on Alteon must match with the service specified on the
server.
• If the application is not recognized by the port, set the application as basic-slb.
>>Virtual Server 1# service 1812
>>Virtual Server 1 radius-auth service# protocol udp
>>Virtual Server 1 radius-auth service# /cfg/slb/virt 1/service 1813
>>Virtual Server 1 radius-acc service# protocol udp
>>Virtual Server 1 radius-auth service# /cfg/slb/virt 1/service 9200
>>Virtual Server 1 9200 service# protocol udp
>>Virtual Server 1 radius-auth service# /cfg/slb/virt 1/service 9201
>>Virtual Server 1 9201 service# protocol udp
>>Virtual Server 1 radius-auth service# /cfg/slb/virt 1/service 9202
>>Virtual Server 1 9202 service# protocol udp
>>Virtual Server 1 radius-auth service# /cfg/slb/virt 1/service 9203
>>Virtual Server 1 9203 service# protocol udp
6. Configure the following filter to examine a RADIUS accounting packet. Set the basic filter
parameters.
>> # /cfg/slb/filt 1
>> Filter 1 # ena
>> Filter 1 # dip 10.10.10.10
>> Filter 1 # dmask 255.255.255.255
>> Filter 1 # proto udp
>> Filter 1 # dport 1813
>> Filter 1 # action redir
>> Filter 1 # group 100
>> Filter 1 # rport 1813
7. Enable RADIUS/WAP persistence.
>> # /cfg/slb/filt 1
>> Layer 7 Advanced# rdswap ena
308
(Add Real Server 2)
(Add Real Server 3)
(Enable Virtual Server 1)
(Select the filter)
(Enable the filter)
(Set the destination IP address)
(Set the destination IP mask)
(Set the protocol to UDP)
(Set the destination port)
(Set the action to redirect)
(Set the group for redirection)
(Set server port for redirection)
(Select the filter)
(Enable RADIUS/WAP persistence)
Document ID: RDWR-ALOS-V2900_AG1302