Radware Alteon Application Manual page 114

Alteon Application Switch Operating System Application Guide
Basic IP Routing
In the example configuration in
Alteon, page 113, the following IP addresses are used:
Table 14: Subnet Routing Example IP Address Assignments
Subnet Devices
1 Primary and Secondary Default Routers
2 First Floor Client Workstations
3 Second Floor Client Workstations
4 Common Servers
2. Assign an IP interface for each subnet attached to Alteon. Since there are four IP subnets
connected to Alteon, four IP interfaces are needed:
Table 15: Subnet Routing Example: IP Interface Assignments
Interface Devices
IF 1 Primary and Secondary Default Routers
IF 2 First Floor Client Workstations
IF 3 Second Floor Client Workstations
IF 4 Common Servers
Use the following commands to configure the IP interfaces:
>> # /cfg/l3/if 1
>> IP Interface 1#
>> IP Interface 1#
>> IP Interface 1#
>> IP Interface 2#
>> IP Interface 2#
>> IP Interface 2#
>> IP Interface 3#
>> IP Interface 3#
>> IP Interface 3#
>> IP Interface 4#
>> IP Interface 4#
3. Set each server and workstation's default gateway to the appropriate IP interface (the one in the
same subnet as the server or workstation).
4. Configure the default gateways to the routers' addresses. This allows Alteon to send outbound
traffic to the routers:
>> IP Interface 5#
>> Default gateway 1#
>> Default gateway 1#
>> Default gateway 1#
114
Figure 11 - Example Configuration IP Subnet Routing with
addr 205.21.17.3
ena
/cfg/l3/if 2
addr 100.20.10.1
ena
/cfg/l3/if 3
addr 131.15.15.1
ena
/cfg/l3/if 4
addr 206.30.15.1
ena
/cfg/l3/gw 1
addr 205.21.17.1
ena
/cfg/l3/gw 2
IP Addresses
205.21.17.1 and 205.21.17.2
100.20.10.2-254
131.15.15.2-254
206.30.15.2-254
IP Interface Address
205.21.17.3
100.20.10.1
131.15.15.1
206.30.15.1
(Select IP interface 1)
(Assign IP address for the interface)
(Enable IP interface 1)
(Select IP interface 2)
(Assign IP address for the interface)
(Enable IP interface 2)
(Select IP interface 3)
(Assign IP address for the interface)
(Enable IP interface 3)
(Select IP interface 4)
(Assign IP address for the interface)
(Enable IP interface 5)
(Select primary default gateway)
(Assign IP address for primary router)
(Enable primary default gateway)
(Select secondary default gateway)
Document ID: RDWR-ALOS-V2900_AG1302