Radware Alteon Application Manual page 581

To configure peers
1. From the Peer Switch menu, define the address settings of the Global Administrator
environment for the peer you want to configure.
You can associate vADCs with the range option. You can enter a combination of single vADCs
and ranges of vADCs. For example: 1, 3-5, 8
Note: For a description of these menu options, see the Alteon Application Switch Operating
System Command Reference.
>> # /cfg/sys/sync/peer
Enter peer switch number (1-5):1
------------------------------------------------------------
[Peer Switch 1 Menu]
addr - Set peer switch IP address
ena - Enable peer switch
dis - Disable peer switch
range - Set synchronization target for a range of vADCs
del - Delete peer switch
cur - Display current peer switch configuration
2. Apply and save. After setting peer switch addresses, vADC configuration is synchronized to the
assigned peers.
To associate peer switches to a single vADC
When you create a vADC, you are prompted to associate peer switches to that vADC (see
Basic vADC with the Creation Dialog, page
associate and configure peers switches to it.
1. Access the Peer Switch Addresses prompt.
>> # /cfg/vadc/sys/sync/
Enter vADC Number [1-28]:1
[Peer Switch Addresses]
Peer switch 1:
Peer switch 2:
Peer switch 3:
Peer switch 4:
Peer switch 5:
Enter peer switch number (1-5):1
------------------------------------------------------------
2. Enter the peer switch number you want to associate to the selected vADC.
3. Apply and save. After setting peer switch addresses, vADC configuration is synchronized to the
assigned peers.
Document ID: RDWR-ALOS-V2900_AG1302
Alteon Application Switch Operating System Application Guide
420). After creating the vADC, you can also separately
10.1.1.1, enabled
20.1.1.1, enabled
30.1.1.1, enabled
40.1.1.1, enabled
0.0.0.0 , disabled
High Availability
Creating a
581