B Dri E Operations By Bacnet 2 - YASKAWA CIMR-ZU A Series Programming Manual

B Dri e Operations by BACnet
B Dri e Operations by BACnet
The drive operations that can be performed by BACnet communication depend on drive parameter settings. This section
explains the functions that can be used and related parameter settings.
Obser in t e Dri e Operation
A controller can perform the following actions with BACnet communications at any time regardless of parameter settings
(except for H5- parameters):
• Observe drive status and drive control terminal status from a controller
• Read and write parameters
• Set and reset faults
• Set multi-function inputs.
Input settings from the input terminals S
Note:
Controllin t e Dri e
Select an external reference and adjust the parameters in
reference using BACnet communications.
e erence Source
External Reference 1
External Reference 2
Refer to b1-01: Frequency Reference Selection for AUTO Mode on page 24
for AUTO Mode on page 25
2 2
and from BACnet communications are both linked by a logical OR operation.
able B 1 Settin Parameters or Dri e Control rom BACnet
Parameter
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-15 Frequency Reference Selection 2
b1-16 Run Command Selection 2
for details on external reference parameter selections.
accordingly to start and stop the drive or set the frequency
Table B.1
Name
and
e uired Settin
Refer to b1-02: Run Command Selection
2
2
2
2