YASKAWA CIMR-ZU A Series Programming Manual page 72

1 F Option Settin s
1 F Option Settin s
F Communication Option Card
Parameters F6-01 through F6-03 and F6-06 through F6-08 are used for EtherNet/IP and LONWORKS options.
F 1 Communications Error Operation Selection
Determines drive operation when a communication error occurs.
No
F6-01
Settin amp to Stop (Use t e Deceleration ime Set to C1 2)
Settin 1 Coast to Stop
Settin 2 Fast Stop (Use t e Fast Stop ime Set to C1
Settin Alarm Only (Continue Operation)
Settin Alarm Only (Continue Operation Usin t e Fre uency e erence Set in d1
Settin Alarm Only (Use t e Deceleration ime Set to C1 2)
F 2 E ternal Fault rom Comm Option Detection Selection
Determines the detection method of an external fault initiated by a communication option (EF0).
No
F6-02 External Fault from Comm. Option Detection Selection
Settin Al ays Detected
Settin 1 Detection durin
F E ternal Fault rom Comm Option Operation Selection
Determines drive operation when an external fault is initiated by a communication option (EF0).
No
F6-03 External Fault from Comm. Option Operation Selection
Settin amp to Stop
Settin 1 Coast to Stop
Settin 2 Fast Stop
Settin Alarm Only (Continue Operation)
F or ue e erence/ or ue Limit Selection rom Comm Option
Selects whether torque reference and torque limit values are assigned to the drive from the network.
No
F6-06 Torque Reference/Torque Limit Selection from Comm. Option
Settin Disabled
Settin 1 Enabled
72
Parameter Name
Communications Error Operation Selection
Parameter Name
un Only
Parameter Name
Parameter Name
Settin
)
Settin
Settin
Settin
an e De ault
0 to 5
)
an e De ault
0, 1
an e De ault
0 to 3
an e De ault
0, 1 0
1
0
1