YASKAWA CIMR-ZU A Series Programming Manual page 32

1 2 b Application
Run command
Output current
Fi ure 1 11 Current Detection Speed Searc at Start or Speed Searc Command by Di ital Input
Notes on Usin Current Detection ype Speed Searc
• Shorten the Speed Search deceleration time set to b3-03 if an oL1 fault occurs while performing Current Detection Speed
Search.
• Current Detection Speed Search is not available when using OLV Control for PM motors.
• Increase the minimum baseblock time set to L2-03 if an overcurrent or overvoltage fault occurs when performing Speed
Search after power is restored following a momentary power loss.
Speed Estimation ype Speed Searc (b 2
This method can be used for a single induction motor connected to a drive. Do not use this method if the motor is one or more
frame size smaller than the drive, at motor speeds above 200 Hz, or when using a single drive to operate more than one motor.
Speed Estimation is executed in the two steps described below:
Step 1 Bac EMF olta e Estimation
This method is used by Speed Search after baseblock (e.g., a power loss where the drive CPU continued to run and the Run
command was kept active). Here, the drive estimates the motor speed by analyzing the back EMF voltage and outputs the
estimated frequency and increases the voltage using the time constant set in parameter L2-04. After that, the motor is accelerated
or decelerated to the frequency reference starting from the detected speed. If there is not enough residual voltage in the motor
windings to perform the calculations described above, the drive will automatically proceed to step 2.
<1> After AC power is restored, the drive will wait for at least the time set to b3-05. If the power interruption is longer than
the minimum baseblock time set to L2-03, the drive will wait until the time set to b3-05 has passed after power is restored
before starting Speed Search.
Step 2 Current In ection
Current Injection is performed when there is insufficient residual voltage in the motor after extended power losses, when Speed
Search is applied with the Run command (b3-01 = 1), or when an External search command is used.
This feature injects the amount of DC current set to b3-06 to the motor and detects the speed by measuring the current feedback.
The drive then outputs the detected frequency and increases the voltage using the time constant set to parameter L2-04 while
looking at the motor current.
2
Decel time set
set to b3-03
OFF ON
Max. output frequency
or the specified
frequency reference
Output
frequency
Minimum Baseblock Time
AC power
supply
ON
Output
frequency
Output
current
Min. Baseblock Time
(L2-03)
Fi ure 1 12 Speed Searc a ter Basebloc
Waits for twice
as long as L2-04
(L2-03)
1)
OFF
Starts at the speed
that was detected
Several milliseconds
b3 -05 <1>
Selected
frequency
reference
b3-02
(Speed search
operation
current)
Selected
frequency
reference