YASKAWA CIMR-ZU A Series Programming Manual page 49

Settin 2 uadratic
The monitor displays 1/(PI output)
Settin Cubic
The monitor displays 1/(PI output)
b /b PI Output 2 Monitor Ma Upper/Lo er
Sets the upper or lower 4 digits of the maximum monitor value. Used with b5-43 or b5-44 to set maximum monitor value of
U5-14 and U5-15 at maximum frequency.
Used for U5-14 and U5-15 only.
Note:
No
b5-43
b5-44
b PI Output 2 Monitor Minimum
U5-14 and U5-15 show Custom PI Output. b5-45 sets the minimum display value at zero speed. This function is effective
when b5-42 is set to 0 (Linear).
Used for U5-14 and U5-15 only.
Note:
No
b5-45
b PI Setpoint Monitor Unit Selection
Sets the HOA keypad display units in U5-01 and U5-04 when b5-20 is set to 3.
No
b5-46
Settin C (Inc o
Settin 1 PSI (Pounds per S uare Inc )
Settin 2 GPM (Gallons per Minute)
Settin F (De rees Fa ren eit)
Settin CFM (Cubic Feet per Minute)
Settin CM (Cubic Meters per our)
Settin LP (Liters per our)
Settin 7 LPS (Liters per Second)
Settin 8 Bar (Bar)
Settin Pa (Pascal)
Settin 1 C (De rees Celsius)
Settin 11 Mtr (Meters)
Settin 12 Ft (Feet)
Settin 1 LPM (Liters per Minute)
Settin 1 CMM (Cubic Meters per Minute)
b 7 e erse Operation Selection 2 by PI Output
Determines whether a negative PI output reverses the direction of drive operation. When the PI function is used to trim the
frequency reference (b5-01 = 3), this parameter has no effect and the PI output will not be limited
(same as b5-11 = 1).
No
b5-47
Settin e erse Disabled
Negative PI output will be limited to zero and the drive output will be stopped.
2
3
Name
PI Output 2 Monitor Max Upper 4 Digits
PI Output 2 Monitor Max Lower 4 Digits
Name
PI Output 2 Monitor Minimum
Name
PI Setpoint Monitor Unit Selection
ater)
Name
Reverse Operation Selection 2 by PI Output
Di its
Settin an e
0 to 9999
0.00 to 99.99
Settin an e
0.0 to 999.9
Settin an e
0 to 14
Settin an e
0, 1
1 2 b Application
De ault
0
0.00
De ault
0.0
De ault
0
1
De ault
1