Drive Operations By Memobus/Modbus; Observing The Drive Operation; Controlling The Drive - YASKAWA P1000 Technical Manual

C.5 Drive Operations by MEMOBUS/Modbus
C.5 Drive Operations by MEMOBUS/Modbus
The drive operations that can be performed by MEMOBUS/Modbus communication depend on drive parameter settings. This
section explains the functions that can be used and related parameter settings.
u

Observing the Drive Operation

PLCs can perform the following actions with MEMOBUS/Modbus communications:
• observe drive status and drive control terminal status
• read and write parameters (not H5-oo)
• reset faults
• set multi-function inputs
Note: Input settings from the input terminals (S1 to S8) and from MEMOBUS/Modbus communications are both linked by a logical OR operation.
u

Controlling the Drive

Select an external reference and adjust the parameters in
reference using MEMOBUS/Modbus communications.
Reference Source
External Reference 1
External Reference 2
Refer to b1-01: Frequency Reference Selection 1 on page 147
148 for details on external reference parameter selections.
207 for instructions on selecting external references 1 and 2.
514
Table C.2 Setting Parameters for Drive Control from MEMOBUS/Modbus
Parameter
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-15 Frequency Reference Selection 2
b1-16 Run Command Selection 2
Table C.2 accordingly to start and stop the drive or set the frequency
Name
and Refer to b1-02: Run Command Selection 1 on page
Refer to Setting 2: External Reference 1/2 Selection on page
YASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual
Required Setting
2
2
2
2