YASKAWA CIMR-ZU A Series Programming Manual page 184

2 Dri e Coolin Fans
Pull out the relay connector and loosen the cap of the cable gland to remove the fan cable.
A
Fi ure 2 2
Remove the screws holding the fan unit in place and slide the cooling fan unit out of the drive.
CAU ION Injury to Personnel. Use two hands to remove the fan unit. Failure to comply may cause the fan unit to fall, resulting in
minor to moderate injury.
Note Use a magnetized screwdriver when removing the screws to prevent the screws from falling.
Unscrew and remove the sealing nut. Yaskawa recommends using a wrench from AVC Corp. of Japan or equivalent.
18
Fi ure 2 28
A
elay connector
emo e t e elay Connector and Loosen t e Cable Gland
Fi ure 2 emo e t e Coolin Fan Unit
emo e t e Dri e Co er A 12
A 12
A 12