YASKAWA CIMR-ZU A Series Programming Manual page 154

1 11 S Special Parameters
AU O Mode Selection
( 1 D)
Open
Closed
-
-
If S5-04 is set to 0, the AUTO and HAND multi-function inputs (setting 6D and 6E) can only be used individually or an oPE03
error will occur.
Settin 2 Normal Operation Mode
When switching AUTO/HAND modes from the HOA keypad, the drive will memorize the operation mode when the power
to the drive is shut off. This will be the initial operating mode when power is reapplied.
When switching AUTO/HAND modes from a Multi-Function Input, the drive will start with the Multi-Function Input setting.
HAND mode: The drive starts with the OFF mode when cycling the power to the drive.
AUTO mode: The drive starts with the AUTO mode when cycling the power to the drive.
OFF mode: The drive starts with the OFF mode when cycling the power to the drive.
S AND Fre uency e erence 1
Sets the frequency reference used in HAND mode when S5-01 is set to 3.
Setting units and range are determined by parameters o1-03, o1-10, and o1-11.
Note:
No
S5-05
S 7 AND ey Function Selection ( OA eypad)
Determines whether the HAND key on the HOA keypad will be enabled for switching between HAND and AUTO.
No
S5-07
Settin Disabled
Settin 1 Enabled
1
able 1 2 AND/AU O Multi Function Inputs Le acy Be a ior (S
AND Mode Selection
( 1 E)
-
-
Open
Closed
S5-02 = 1 AND
S5-02 = 1 AND
HAND key
AUTO key
Fi ure 1 8
it Memory
Name
HAND Frequency Reference 1
Name
HAND Key Function Selection (HOA Keypad)
Fre uency e erence
Based on S5-01
Based on b1-01
Based on b1-01
Based on S5-01
OFF key AND o2-02 = 1
AU O
Fref via b1-01
Run via b1-02
AUTO key
OR run command
HAND key
AND
Fref via S5-01
Run On
OFF key
Le acy Be a ior (S
)
un Command
Based on b1-02
OFF
Fref via b1-01
Run Off
)
Settin an e
0.00 to [E1-04]
Settin an e
0, 1
De ault
0.00 Hz
De ault
1